跳转到主内容

常见问题解答: ARP 广播风暴:信息和影响

Views:
169
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
network
Last Updated:

适用于

  • ONTAP 9 
  • 集群模式 Data ONTAP

问题描述 

报告以下事件是什么 /mroot/etc/log/ems ?影响可能是什么?

示例:

"[XXXXXX: NwkThd_0X netif.rateLimitThreshold:error]: High rate limit on the network interface e0* for broadcast protocol ARP is detected"

问题解答

  • 此消息表示传入 ARP 广播风暴。
    • 它是通过一个监控流入的过程生成的,用于在发生任何异常事件时指示我们。
    • 在监控的最后一秒,接口收到的 ARP 广播数据包数量非常多(在本例中为 >5000 )。
    • 之后,系统还会经过半秒( 500 毫秒)的丢弃窗口,以使系统稍作冷却。

注意:在网络接口上达到协议速率阈值时会出现此消息。

更正操作:

  • 修复错误的网络配置或错误的设置,使广播数据包突然出现峰值以使节点关闭。
  • 可以使用 "bootarg.arp.ratelimit.threshold" 启动参数修改此阈值。

其他信息

  • 以往,此类风暴是由于环路等网络配置不当或网络设备运行不正常而生成的。
  • 在连接到这些端口的同一广播域的设备上,检查是否存在在同一时间段内发生的任何此类活动。
  • 在某些情况下,这些 ARP 风暴可能会导致系统无响应或最终中断,因为它们可能会耗尽网络资源。

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
Scan to view the article on your device