升级到ONTAP 9.131后、本机VLAN端口显示已降级
适用场景
- ONTAP 9.13.1.及更高版本
- VLAN
- 连接故障管理(CFM)
问题描述
- 本机/未标记VLAN端口(a0a、e0a、e1c)报告由于而降级
L2_reachability - 使用 VLAN (例如a0a-100、e0a-20或e1c-25)的端口不会显示已降级
- 以太网交换机不允许 在相应的链路聚合组(LAG)和/或成员端口上使用本机/ 未标记VLAN、从而导致在这些端口上丢弃未标记的帧
::>network port show
Node: node1
Port IPspace Broadcast Domain Link MTU Admin/Oper Status
--------- ------------ ---------------- ---- ---- ----------- --------
a0a Default Data up 1500 -/- degraded
a0a-100 Default Data up 1500 -/- healthy
a0a-200 Default Data up 1500 -/- healthy
e0e Default - up 1500 auto/10000 degraded
e0f Default - up 1500 auto/10000 degraded
::>network port reachability show
Node Port Expected Reachability Reachability Status
--------- -------- ------------------------------------ ---------------------
node1
a0a Default:Default no-reachability
a0a-100 Default:Default ok
a0a-200 Default:Default ok
e0e Default:Default no-reachability
e0f Default:Default no-reachability
::>network port ifgrp show
Port Distribution Active
Node ifgrp Function MAC Address Ports Ports
------ ------- ------------ -------------- ------- ---------------
node1 a0a ip b8:f8:7a:01:02 full e0e,e0f
- 此显示也可能类似于
::*>network port show
Node: node1
Port IPspace Broadcast Domain Link MTU Admin/Oper Status
--------- ------------ ---------------- ---- ---- ----------- --------
a0a Default Data up 1500 -/- degraded
a0a-100 Default Data up 1500 -/- healthy
a0a-200 Default Data up 1500 -/- healthy
e0e Default - up 1500 auto/10000 healthy
e0f Default - up 1500 auto/10000 healthy
- 如果此问题描述仅在接口组(ifgrp)的成员端口上可见、则应使用以下KB：