跳转到主内容

Unable to migrate Vserver peer relationships after switchover (SnapMirror migrated successful)

  1. 最后更新
  2. 另存为PDF
Views:
29
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

​ ​

Applies to

  • MetroCluster
  • Source and Destination is MetroCluster are in switchover state
  • Switchover

Issue

When performing the following steps with an active SVM/vserver peer SnapMirror setup, the below alert is being triggered

ClusterB::> metrocluster operation show
Operation: switchover
State: completed-with-manual-recovery-needed
Errors: destinationcluster (manual recovery required): Internal error. Unable to migrate Vserver peer relationships. Reason: (Failed to communicate with peer cluster "sourcecluster". Reason: Failed to contact peer cluster "destination" at addresses: 1.1.1.1. RPC: Remote system error - Operation timed out). Contact technical support for assistance.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.