在 4 节点 MetroCluster 的 boot_recovery 过程中，Option 6 会将 ha-config 从 mcc 或 mccip 重置为 ha

最后更新
另存为PDF

Views:: 213

Visibility:: Public

Votes:: 0

Category:: metrocluster

Specialty:: metrocluster

Last Updated:

适用于

ONTAP 9
AFF A400
FAS8300
AFF A800
4 节点 MetroCluster FC
4 节点 MetroCluster IP

问题

在 4 节点 MetroCluster 配置中运行 9.7.X 的 AFF A400 或 FAS8300 上执行需要 boot_recovery 过程的维护（ARL headswap、引导设备更换）期间，必须在受影响节点重新引导到 ONTAP 之前将备份配置文件恢复到新的引导介质上。
请注意，使用特殊启动菜单中的选项 6 恢复 VARFS 备份配置文件的尝试失败。
在 4 节点 MetroCluster FC 配置中，您可能会看到类似的控制台消息如下所示。

Jun 13 08:09:04 [Node1:fci.adapter.error:notice]: Fibre Channel adapter driver encountered error "Either the platform does not support this type of FC/FCVI adapter, or the platform supports the adapter but the chassis and controller variables are not set correctly." on adapter 2a. Jun 13 08:09:04 [Node1:fci.adapter.error:notice]: Fibre Channel adapter driver encountered error "Either the platform does not support this type of FC/FCVI adapter, or the platform supports the adapter but the chassis and controller variables are not set correctly." on adapter 2b. Jun 13 08:09:29 [Node1:scsitarget.slifct.fwAutoBoot:notice]: FC target HBA 1c firmware version updated from 11.4.277.0 to 12.2.390.0. The controller will be rebooted automatically to enable the new HBA firmware. Rebooting after updating Emulex FC firmware.