在 MetroCluster FC 到 IP 转换期间出错，阻止转换

最后更新
另存为PDF

Views:

Visibility:: Public

Votes:: 0

Category:: metrocluster

Specialty:: metrocluster

Last Updated:

适用于

MetroCluster FC
MetroCluster IP
将 FC 转换为 IP

问题描述

在开始过渡之前，命令

metrocluster transition enable -transition-mode non-disruptive

未按照文档中的要求运行。

进一步步骤：

将旧节点上的集群接口移动到新交换机
将新节点添加到集群中

如果您在稍后的过程中运行该命令，将会出现类似于下面的错误

Error: command failed: This operation is supported only on a MetroCluster over FC configuration

尝试在新节点上创建 MetroCluster 接口将显示错误：cluster01::> metrocluster configuration-settings interface create -cluster-name cluster1 -home-node node01 -home-port e2a -address xx.x.x.x -netmask 255.255.255.0

Error: command failed: One or more nodes in cluster "cluster1" do not have HAOSC set to "mccip". Use the "ha-config modify chassis mccip" and "ha-config modify controller mccip" commands in maintenance mode to change the HAOSC settings on nodes in cluster "cluster1", and try the command again