跳转到主内容

升级到NXOS 9.3 (6)- 9.3 (8)后无法应用RC框架

  1. 最后更新
  2. 另存为PDF
Views:
5
Visibility:
Public
Votes:
0
Category:
fabric-interconnect-and-management-switches
Specialty:
hw
Last Updated:

适用场景

  • Cisco Nexus 3132Q-V集群交换机
  • NXOS 9.3 (6)- 9.3 (8)

问题描述

将Cisco Nexus 3132Q-V集群交换机升级到NXOS 9.3 (6)- 9.3 (8)版后、应用RCV 失败：

switch# conf term Enter configuration commands, one per line. End with CNTL/Z. switch(config)# policy-map type queuing SampleMap Invalid class referenced

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.