跳转到主内容

发送 SNMP 测试陷阱失败

  1. 最后更新
  2. 另存为PDF
Views:
9
Visibility:
Public
Votes:
0
Category:
e-series-systems
Specialty:
esg
Last Updated:

适用于

  • E-Series
  • SANtricity 操作系统

问题

通过 SANtricity System Manager GUI 发送 SNMP 陷阱目标测试消息失败，并显示以下错误：
The operation cannot be completed because the specified SNMP trap destination is not reachable with the current controller IPV4 network configuration. This could be because:
(1) IPV4 is not enabled on at least one port with an active connection on each controller OR
(2) the following conditions exist on one or both controllers:
   (a) the controller is configured with a static IP address (i.e. does not obtain it's IP configuration via DHCP) AND
   (b) an IPV4 gateway is not assigned on that controller AND
   (c) the IP address of the controller and the specified trap destination address are not part of the same subnet

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.