添加磁盘架后持久出现false SinglePathToDiskShelf_Alert

最后更新
另存为PDF

Views:: 5

Visibility:: Public

Votes:: 0

Category:: disk-shelves<a>2009-179114</a><a>翻译</a>

Specialty:: hw

Last Updated:

适用场景

存储架扩展
正确的SAS布线
多路径中的HA对

问题描述

SinglePathToDiskShelf警报示例：

::> system health alert show

Node: node_name

Resource: Shelf 1.1

Severity: Major

Indication Time: Wed May 11 21:14:22 2022

Suppress: false

Acknowledge: false

Probable Cause: Controller node_name has only a single-path configuration to disk shelf 1.1. This might occur

when the controller does not have dual-path configuration to stack 1, a SAS HBA port on the

controller connected to the disk shelf is disabled, or shelf-to-shelf cabling is incorrect.

Possible Effect: Access to disk shelf 1.1 via controller node_name might be lost with a failure of controller 0a port, a

single shelf-to-shelf cable or a single disk shelf IOM.

Corrective Actions: 1. Consult the guide applicable to your IOM12 disk shelf to review cabling rules and complete the SAS cabling worksheet for your system.

2. Connect controller node_name to the first and last disk shelf of stack 1 using active SAS HBA ports.

3. Verify that controller node_name is cabled to IOM A at one end and IOM B at another end of stack 1.

4. If disk shelf 1.1 is located between two disk shelves within stack 2, verify that IOM A and IOM B are properly cabled to their independent domains.

5. Contact technical support if the alert persists.

临时EMS警报消息：

Tue May 17 20:08:01 +0200 [node_name: mgwd: callhome.hm.alert.major:alert]: Call home for Health Monitor process nchm: SinglePathToDiskShelf_Alert[12345678912345678912].

Tue May 17 20:09:31 +0200 [node_name: schmd: hm.alert.raised:alert]: Alert Id = DualControllerHa_Alert , Alerting Resource = 0a:0b:0c:0d:0e:0f:00:0a raised by monitor system-connect

Tue May 17 20:13:01 +0200 [node_name: mgwd: callhome.hm.alert.major:alert]: Call home for Health Monitor process schm: DualControllerHa_Alert[0a:0b:0c:0d:0e:0f:00:0a].

Tue May 17 20:24:31 +0200 [node_name: schmd: hm.alert.cleared:notice]: Alert Id = DualControllerHa_Alert , Alerting Resource = 50:0a:09:80:0e:97:15:80 cleared by monitor system-connect