控制器警示 LED 亮起，并由 SP 设置

最后更新
另存为PDF

Views:: 48

Visibility:: Public

Votes:: 0

Category:: fas-systems

Specialty:: hw

Last Updated:

适用于

FAS8040
FAS8020
服务处理器 (SP)

问题

控制器警示 LED 亮起。
可在以下命令输出中找到 SP 设置的。

ONTAP 集群模式

示例：

cluster::*> system controller fru led show Node FRU Type Bay Slot State Lit By --------------------- ----------- --- ---- ------- ------- cluster-01 controller A 1 off - pci - 1 off - pci - 2 off - pci - 3 off - pci - 4 off - batt-nv - 1 off - boot - 1 off - dimm-nv - 1 off - dimm - 1 off - dimm - 2 off - dimm - 3 off - dimm - 4 off - cluster-02 controller B 1 on SP pci - 1 off - pci - 2 off - pci - 3 off - pci - 4 off - batt-nv - 1 off - boot - 1 off - dimm-nv - 1 off - dimm - 1 off - dimm - 2 off - dimm - 3 off - dimm - 4 off -

Data ONTAP 8.2 7-模式

示例：

node*> fru_led status Controller slot B: On (lit by SP)

DIMM slot 1: Off DIMM slot 2: Off DIMM slot 3: Off DIMM-NV slot 1: Off PCI slot 1: Off PCI slot 2: Off NV battery 1: Off Boot device 1: Off