跳转到主内容

在新设置下升级到集群模式Data ONTAP 8.3失败

Views:
20
Visibility:
Public
Votes:
0
Category:
data-ontap-8
Specialty:
7dot
Last Updated:

适用场景

  • Data ONTAP 8.3

问题描述

如果在新设置中升级到集群模式Data ONTAP 8.3失败、并显示以下错误:


********************************************************************************
* This filer contains FreeBSD configured ports.
* You must correct this failure to avoid service disruptions.
*
* The following corrective action is required:
* Set the -privilege level do diagnostic:
* set -privilege diagnostic
* Issue the following commands:
* systemshell -node <node> 'kenv -upq bootarg.activatebsdport'
* systemshell -node <node> 'kenv -upq bootarg.activatebsdport.persist'
* systemshell -node <node> 'kenv -upq bootarg.givebsdmgmtport'
*******************************
*************************************************
Retry the image installation after taking corrective action.
ERROR: LIF sufficiency check failed.
Install Failed.
Install Validation Failed. ERROR: LIF sufficiency check failed.
Error: command failed: Install Failed. Install Validation Failed. ERROR: LIF sufficiency check failed.

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.