跳转到主内容

This Site will be down for up to 3 hours on December 2, 2023 from 8 PM - 11 PM PST, to deploy an infrastructure update.

在 FAS2552 和 FAS2554 上，端口 e0c 和 e0d 显示为脱机 硬件更换后

  1. 最后更新
  2. 另存为PDF
Views:
36
Visibility:
Public
Votes:
0
Category:
fas-systems
Specialty:
hw
Last Updated:

适用于

  • FAS2552
  • FAS2554

问题

更换主板后，端口 e0C 和 e0D 会显示脱机和链路断开，即使已插入缆线且 CNA 卡设置正确。

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
Scan to view the article on your device
  1. 返回顶部
  • 这篇文章对您有帮助吗？

推荐文章

  1. 文章类型
    参考
    Confidence
    Validated
    Flag
    Not Flagged
    Governance
    Experience
    KCS Enabled
    Yes
    Visibility
    Public
  2. 标签
    1. product-categories:fas-systems
    2. specialty:hw