跳转到主内容

升级到9.6P6后、在Intel 10G以太网IX1-SFP+卡上关闭链路

Views:
22
Visibility:
Public
Votes:
0
Category:
fas-systems
Specialty:
hw
Last Updated:

 

适用场景

  • Intel双10 Gb以太网IX1-SFP+卡
  • ONTAP 9.6 和 9.7%

问题描述

  • 在运行ONTAP 9.6及更高版本时重新启动后、Intel 10G以太网IX1-SFP+卡的某些端口关闭。
  • 在多LACP ifgroup中、这些端口将降级。
  • 在节点关闭/打开电源后、问题描述 仍会保持不变。
  • ""的输出示例sysconfig -a。在第二个端口中、ifgroup在一个端口关闭的情况下更改为"部分"。即使在同一卡中、任何其他端口也可以正常运行。:

slot 3: Dual 10 Gigabit Ethernet Controller IX1-SFP+
e3a MAC Address:    90:e2:ba:d4:5d:bc (auto-unknown-fd-down)
e3b MAC Address:    90:e2:ba:d4:5d:bd (auto-unknown-fd-down) 

slot 3: Dual 10 Gigabit Ethernet Controller IX1-SFP+
e3a MAC Address:    90:e2:ba:d8:0d:00 (auto-unknown-fd-down)
e3b MAC Address:    90:e2:ba:d8:0d:01 (auto-10g_sr-fd-up)

  • "ifconfig"的输出示例、此端口报告无托架。 
 e3a: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 9000 options=6c07bb<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,JUMBO_MTU,VLAN_HWCSUM,TSO4,TSO6,LRO,VLAN_HWTSO,LINKSTATE,RXCSUM_IPV6,TXCSUM_IPV6> ether 90:e2:ba:d4:63:30 hwaddr 90:e2:ba:d4:63:30 media: Ethernet autoselect (autoselect <full-duplex>) status: no carrier

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.