跳转到主内容

为什么应用RCF后、Cisco交换机的running-config中未显示"cdp enable"?

Views:
2
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
network
Last Updated:

适用场景

  • 基于 IP 的 MetroCluster
  • 集群交换机
  • Cisco
  • 参考配置文件(RCF)
  • Cisco 发现协议( CDP )

问题解答

  • cdp enable 只有在全局禁用的情况下、此设置才会显示在running-config中
  • show cdp neighbors 要验证CDP设置、请改用命令

site-a-sw2# show cdp neighbors
Capability Codes: R - Router, T - Trans-Bridge, B - Source-Route-Bridge
                  S - Switch, H - Host, I - IGMP, r - Repeater,
                  V - VoIP-Phone, D - Remotely-Managed-Device, s - Supports-STP-Dispute
Device-ID         Local Intrfce  Hldtme Capability  Platform      Port ID
cbc-mgmt-sw-r01     mgmt0          138    S I       WS-C2960-24TT Fas0/22
cluster-a-01        Eth1/3         176    H         AFF-A800      e1a
cluster-a-02        Eth1/4         174    H        AFF-A800      e1a

追加信息

对于Nexus OS的不同版本、请访问 Cisco 网站以获取有关命令的更多文档

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.