跳转到主内容

在Brocade X6-8导向器交换机中的什么位置安装FC32-48端口刀片?

Views:
64
Visibility:
Public
Votes:
0
Category:
fabric-interconnect-and-management-switches
Specialty:
brocade
Last Updated:

适用场景

Brocade X6交换机

问题解答

客户购买Brocade X6-8控制器交换机时、其X6-8机箱中安装了挡片。所有附加的FC32-48端口刀片均单独发售、需要在开机和启动之前安装到机箱中

。机箱最多支持8个FC32-48端口刀片、但是、购买交换机时、可能会附带少于一个完整的刀片来填充机箱

  • FC32-48端口刀片始终成对安装。此图显示了机箱的端口侧视图以及表1中的说明
  • 从图中、数字5指向2个半高插槽控制处理器刀片。面向设备的端口侧、半高插槽位于左侧、编号为1 (顶部插槽)和2 (底部插槽)
  • 在图中、2号指向插槽7和8中的核心路由刀片
  • 插槽(即端口刀片的左侧空插槽)。插槽9-12是右侧端口刀片插槽组。对于每对刀片、请在左侧插槽中安装一个刀片、在右侧插槽中安装另一个刀片。有关刀片式服务器的位置和插槽配对、请参阅表2
  • 确保将刀片式服务器正确插入机箱、并使用拉杆将刀片式服务器锁定到位
  • 安装后、请务必将刀片式服务器螺钉拧紧至机箱、否则交换机在启动时可能无法识别刀片式服务器
Brocade x6-8.png
  表1:图问题描述
1
通风口 
2
核心路由刀片(CR32-8)
3
端口刀片(FC32-48) 
4
线缆管理梳
5
控制处理器刀片(CPX6或 CPX)–插槽1 (上部)
、插槽2 (下部)
   
   
   
   
   

 

 

表 2  
设置编号 插槽配对
1 3和9
2 4和10
3 5和11
4 6和12

 

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.