由于 " 无法恢复数据复制模块的本地数据库 " ，系统在重新启动后无法启动

最后更新
另存为PDF

Views:: 146

Visibility:: Public

Votes:: 0

Category:: fas-systems<a>恢复</a><a>电源中断</a><a>关闭</a><a>加载程序</a><a>RDM</a><a>rdb</a><a>bootarg.init.boot_recovery</a><a>bootarg</a><a>重新定位</a><a>根卷无法正常工作</a>

Specialty:: hw

Last Updated:

适用场景

所有AFF 和FAS 平台
ONTAP
断电、控制器重新定位或在升级或其他重新启动期间

问题描述

node show的控制台日志：

******************************************************

* This is a serial console session. Output from this *

* session is mirrored on the SP console session. *

******************************************************

***********************

** SYSTEM MESSAGES **

***********************

Internal error: Cannot open corrupt replicated database. Automatic recovery

attempt has failed or is disabled. Check the event logs for details. This node

is not fully operational. Contact support personnel for the root volume recovery

procedures.

节点的EMS消息：

Mar 28 17:03:46 [NODE_B:rdb.recovery.failed:EMERGENCY]: Error: Unable to find a master. Unable to recover the local database of Data Replication Module: Management.

Mar 28 17:03:46 [NODE_B:spm.mgwd.process.exit:EMERGENCY]: Management Gateway (mgwd) subsystem with ID 1944 exited as a result of signal normal exit (0). The subsystem will attempt to restart.

节点启动且可以登录、但集群命令显示的输出不正确：

::> cluster show

错误："show"不是可识别的命令

::> set advanced

::*> cluster ring show

Error: "show" is not a recognized command

ROOT VOLUME NOT WORKING PROPERLY: RECOVERY REQUIRED 在启动/登录阶段显示错误消息。
bootargcorrupt recovery 加载程序中为和/或指定了一些值。示例：

LOADER-B> printenv bootarg.rdb_corrupt

Variable Name Value

-------------------- --------------------------------------------------

bootarg.rdb_corrupt 0500000000

LOADER-B> printenv bootarg.init.boot_recovery

Variable Name Value

-------------------- --------------------------------------------------

bootarg.init.boot_recovery 80

注意： 如果未设置启动程序，则会显示为未定义。