由于交换机被禁用、FC适配器显示"Link disconnected (链路已断开)"
适用场景
- ONTAP 9
- Brocade FC 交换机
问题描述
network fcp adapter show显示"链路断开"
cluster1::> network fcp adapter show
Connection Port Admin Operational
Node Adapter Established Address Status Status
------------ -------- ----------- ------- -------- ---------------
cluster1-01 0e true 10000 up online
cluster1-01 0f true 0 up link disconnected
cluster1-02 0e true 0 up link disconnected
cluster1-02 0f true 10000 up online
sysconfig -a显示"无链路"状态
cluster1::> system node run -node cluster1-01 -command sysconfig -a
slot 0: Fibre Channel Target Host Adapter 0f
(QLogic 8324 (8362) rev. 2, <LINK DISCONNECTED>)
Firmware rev: 8.9.0
Flash rev: 7.0.3
Host Port Addr: 000000
FC Nodename: 50:0a:09:80:xx:xx:xx:xx (500a0980xxxxxxxx)
FC Portname: 50:0a:09:82:xx:xx:xx:xx (500a0982xxxxxxxx)
Connection: No link
Switch Port: Unknown
slot 0: Fibre Channel Target Host Adapter 0e
(QLogic 8324 (8362) rev. 2, <LINK DISCONNECTED>)
Firmware rev: 8.9.0
Flash rev: 7.0.3
Host Port Addr: 000000
FC Nodename: 50:0a:09:80:xx:xx:xx:xx (500a0980xxxxxxxx)
FC Portname: 50:0a:09:81:xx:xx:xx:xx (500a0981xxxxxxxx)
Connection: No link
Switch Port: Unknown
- 端口的Rx和Tx为0.0 uW
- 启用交换机端口时出现错误"port cannot be enabled as the switch is disabled "。