跳转到主内容

集群交换机未显示在"System Cluster-Switch Show"命令的输出中

  1. 最后更新
  2. 另存为PDF
Views:
8
Visibility:
Public
Votes:
0
Category:
fabric-interconnect-and-management-switches<a>2009-261551</a>
Specialty:
hw
Last Updated:

适用场景

  • ONTAP 9
  • 集群网络交换机

问题描述

  • system cluster-switch show或 system switch ethernet show 命令的输出不会报告集群交换机。
  • 交换机可以完全正常运行、并且所有集群端口链路均已启动。
  • 以下运行状况警报将在事件日志中生成：

[node: cshmd: hm.alert.raised:alert]: Alert Id = SwitchlessConfig_Alert , Alerting Resource = cluster raised by monitor cluster-switch

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.