ONTAP还原后、system node upgrade -还原show命令会显示"Status：not -Need"

最后更新
另存为PDF

Views:: 8

Visibility:: Public

Votes:: 0

Category:: ontap-9

Specialty:: core<a>2009年884715.</a>

Last Updated:

适用场景

ONTAP 9

问题描述

在执行ONTAP还原(9.7 -> 9.6)后、 system node upgrade-revert show 显示命令 Status:not-needed

 　　-------------------------------------------------------------------------------------------------- 　　Node:node1 Status:not-needed　　Status Message: The node configuration is up-to-date. No upgrade is needed 　　Vers Phase Status Upgrade Phase Status Message 　　------------------------------------------------------------------------------ 　　510 pre-root applied No upgrade is required for this phase. 　　510 pre-apps applied Upgrade successful. 　　510 post-apps applied Upgrade successful. 　　700 pre-root applied No upgrade is required for this phase. 　　700 pre-apps applied Upgrade successful. 　　700 post-apps applied Upgrade successful. 　　900 pre-root applied No upgrade is required for this phase. 　　900 pre-apps applied Upgrade successful. 　　900 post-apps applied Upgrade successful. 　　9 entries were displayed. 　　-------------------------------------------------------------------------------------------------

重新运行还原命令不会更改的状态 not-needed

::> set advanced ::*> system node upgrade-revert upgrade -node node1 The node configuration is up-to-date. No upgrade is needed.