跳转到主内容

更换主板后，端口e0e、e0f、e0g和e0h未在CLI中显示

  1. 最后更新
  2. 另存为PDF
Views:
Visibility:
Public
Votes:
0
Category:
fas-systems
Specialty:
hw
Last Updated:

适用于

  • ONTAP 9
  • AFF A300，FAS8200
  • UTA2 端口

问题描述

  • 以太网端口 e0e、e0f、e0g 和 e0h 不会出现在 CLI 或 System Manager 中
  • 端口 LED 指示灯熄灭

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.