e1a或e1b端口关闭

最后更新
另存为PDF

Views:: 39

Visibility:: Public

Votes:: 0

Category:: aff-series

Specialty:: hw

Last Updated:

适用于

AFF A800
FAS2820

问题

集群 e1a 或 HA 互连 e1b 端口在 ::> system node run -node node_name -command sysconfig -a 输出中已关闭。示例：

slot 1: Dual 40/100G Ethernet T62100-CR e1a MAC Address: 00:07:43:51:03:00 (auto-unknown-fd-down) e1b MAC Address: 00:07:43:51:03:08 (auto-unknown-fd-down) Device Type: T6 2 Firmware Version: 1.24.12.0 Part Number: 110122860B1 Hardware Revision: 0 Serial Number: PT09190900

ONTAP 事件消息系统 (EMS) 报告。示例：

Mon Apr 14 18:48:11 +0900 [node_name: intr: netif.linkDown:info]: Ethernet e0a: Link down, check cable.

或
netif.linkDown: Ethernet a0b: Link down, check cable.
netif.linkDown: Ethernet e1b: Link down, check cable.
vifmgr.portdown: A link down event was received on node ***, port e1a.
net.ifgrp.lacp.link.inactive: ifgrp a0b, port e1a has transitioned to an inactive state. The interface group is in a degraded state.
netif.linkDown: Ethernet e1a: Link down, check cable. ～ netif.linkUp: Ethernet e1b: Link up. netif.linkUp: Ethernet e1a: Link up.

在确认布线与该端口连接良好后，问题仍然存在。
将端口连接到其他已知正常工作的交换机端口后，问题仍然存在。
重新插拔卡后，问题仍然存在。