Cisco集群交换机ISL端口已关闭

最后更新
另存为PDF

Views:: 6

Visibility:: Public

Votes:: 0

Category:: ontap-9

Specialty:: hw<a>2009627159</a>

Last Updated:

适用场景

ONTAP 9
N9K-C9336C-x2

问题描述

设置新的Cisco集群交换机后、ISL端口显示为关闭状态。
交换机 1

`show interface brief` -------------------------------------------------------------------------------- Ethernet VLAN Type Mode Status Reason Speed Port Interface Ch # -------------------------------------------------------------------------------- Eth1/35 1 eth trunk down Link not connected auto(D) 1 Eth1/36 1 eth trunk down Link not connected auto(D) 1

交换机 2

`show interface brief` -------------------------------------------------------------------------------- Ethernet VLAN Type Mode Status Reason Speed Port Interface Ch # -------------------------------------------------------------------------------- Eth1/35 1 eth trunk down Link not connected auto(D) 1 Eth1/36 1 eth trunk down Link not connected auto(D) 1
两个交换机上的一个接口均显示"收发器不受支持"。
交换机 1

Ethernet1/35    transceiver is not supported

    Calibration info not available

    Calibration info not available

    Calibration info not available

    Calibration info not available

    Calibration info not available

    Calibration info not available

    Calibration info not available

    Calibration info not available

    Calibration info not available

    Calibration info not available

    Calibration info not available

    Calibration info not available

    Calibration info not available

    Calibration info not available

    Calibration info not available

    Calibration info not available

    Calibration info not available

Ethernet1/36     transceiver is present     type is QSFP-100G-PCC     name is Molex     part number is 112-00574     revision is B0     serial number is 93A2232621382     nominal bitrate is 25500 MBit/sec     Link length supported for copper is 2 m     cisco id is 17     cisco extended id number is 0

DOM is not supported

交换机 2

`show interface transceiver detail`

Ethernet1/35    transceiver is not supported

    Calibration info not available

    Calibration info not available

    Calibration info not available

    Calibration info not available

    Calibration info not available

    Calibration info not available

    Calibration info not available

    Calibration info not available

    Calibration info not available

    Calibration info not available

    Calibration info not available

    Calibration info not available

    Calibration info not available

    Calibration info not available

    Calibration info not available

    Calibration info not available

    Calibration info not available

Ethernet1/36     transceiver is present     type is QSFP-40G-CR4     name is CISCO-JPC     part number is P3007U101000-1     revision is A0     serial number is JPC25090339-A     nominal bitrate is 10300 MBit/sec per channel     Link length supported for copper is 1 m     cisco id is 13     cisco extended id number is 16     cisco part number is 37-1322-03     cisco product id is QSFP-H40G-CU1M     cisco version id is V03

DOM is not supported
在show日志记录中会显示以下事件。

`show logging log` SW1 %ETHPORT-3-IF_UNSUPPORTED_TRANSCEIVER: Transceiver on interface Ethernet1/35 is not supported SW2 %ETHPORT-3-IF_UNSUPPORTED_TRANSCEIVER: Transceiver on interface Ethernet1/35 is not supported
根据 Hardware Universe，支持使用的电缆。