跳转到主内容

在应用RC框架1.8或更高版本时、出现Cisco 3132Q消息"未配置TCAM区域"

  1. 最后更新
  2. 另存为PDF
Views:
3
Visibility:
Public
Votes:
0
Category:
fabric-interconnect-and-management-switches<a>20095917</a><a>进行翻译</a>
Specialty:
hw
Last Updated:

适用场景

  • Cisco 3132Q集群交换机
  • RC框架1.8及更高版本

警告

文章不适用于MetroCluster IP配置

问题描述

  • 将1.8 RCF(或更高版本)应用于集群交换机时、会出现以下警报：
Unable to perform the action due to incompatibility:  Module 1 returned status "TCAM region is
not configured. Please configure TCAM region and retry the command"

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.