跳转到主内容

Brocade FC交换机管理端口已关闭

Views:
21
Visibility:
Public
Votes:
0
Category:
fabric-interconnect-and-management-switches
Specialty:
brocade<a>2009153322</a>
Last Updated:

适用场景

Brocade FC 交换机

问题描述

  • Brocade管理端口不可访问、无发送或接收流量、错误转储中无错误表示硬件问题描述。
  • 交换缆线和端口不会解决问题描述 问题
  • 通过CLI检查BroCADE交换机上的端口配置(串行连接):

switch:admin> ethif --show eth0

  • $ ethtool eth0
    Settings for eth0:
    Supported ports: [ TP MII ]
    Supported link modes: 10baseT/Half 10baseT/Full
    100baseT/Half 100baseT/Full
    Supports auto-negotiation: Yes
    Advertised link modes: 10baseT/Half 10baseT/Full
    100baseT/Half 100baseT/Full
    Advertised auto-negotiation: Yes
    Speed: 100Mb/s
    Duplex: Full
    Port: MII
    PHYAD: 1
    Transceiver: external
    Auto-negotiation: off
    Link detected: no

  • 如果端口设置为MII、请使用:
    $ mii-tool -vvv:
    [...]
    eth0: 100 Mbit, full duplex, no link
    [...]
    basic mode: 100 Mbit, full duplex
    basic status: no link
    capabilities: 100baseTx-FD 100baseTx-HD 10baseT-FD 10baseT-HD
    advertising: 100baseTx-FD 100baseTx-HD 10baseT-FD 10baseT-HD

     
  • Cisco交换机上的已连接交换机端口:
#sh int status | in AB04
Gi1/0/15 AB04.AD.01 notconnect 666 full 1000 10/100/1000BaseTX
Gi1/0/16 AB04.AD.02 notconnect 666 full 1000 10/100/1000BaseTX
 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.