跳转到主内容

无法启动 ONTAP 并显示 NVDIMM 故障错误消息

  1. 最后更新
  2. 另存为PDF
Views:
9
Visibility:
Public
Votes:
0
Category:
fas-systems
Specialty:
hw
Last Updated:

适用场景

FAS8300

问题描述

无法启动 ONTAP ，出现以下消息

Loading NVDIMM0 firmware version 2.6.2.c (was 2.5.3.c)

Programming NVDIMM0 FW. This could take over 8 minutes. Please wait...

.Sun Sep 12 03:45:44 2021 [nvdimm.fw.upgrade.failure:ERROR]:NVDIMM controller in slot-11 failed to upgrade firmware because it is at ARMed state or has valid data

Attempting to use existing varfs on /dev/nvrd1

Warning: Freeing unused FAT sector 569224 8 3600

System DIMM configuration is not supported by FAS8300

Halting...

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.