跳转到主内容

"storage failover hwassist show" 导致未收到有效的端口/IP 地址配置

  1. 最后更新
  2. 另存为PDF
Views:
55
Visibility:
Public
Votes:
0
Category:
not set
Specialty:
hw
Last Updated:

适用于

  • ONTAP 9
  • AFF A900
  • AFF A800
  • AFF A700
  • AFF A400
  • FAS 8700
  • FAS 8300
  • 集群设置

问题描述

  • 运行集群设置后，发出"storage failover hwassist show"命令时，将显示以下错误：
cluster::*> storage failover show
 
 
node         hwassist  hwassist-partner-ip  hwassist-status
------------ --------  -------------------  ---------------------
cluster-01   true     192.0.2.85          inactive:No valid port/IP address config received.
cluster-02   true     192.0.2.84      

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.