NetApp adopts Microsoft’s Business-to-Customer (B2C) Identity Management

Effective December 3 - NetApp adopts Microsoft’s Business-to-Customer (B2C) identity management to simplify and provide secure access to NetApp resources. For accounts that did not pre-register (prior to Dec 3) access to your NetApp data may take up to 1 hour as your legacy NSS ID is synchronized to the new B2C identity. To learn more, Read the FAQ and Watch the video. Need assistance? Complete this form and select “Registration Issue” as the Feedback Category.

SwitchifisLDownwarn_alert 来自链路聚合 xx 的警报

最后更新
另存为PDF

Views:: 16

Visibility:: Public

Votes:: 0

Category:: ontap-9

Specialty:: core

Last Updated:

This KB article is linked to the Interactive Workflow Upgrade ONTAP software/Service Processor Firmware/Switch configuration.

状态信息

适用场景

ONTAP 9.5P4
CN1610

问题描述

将 ONTAP 升级到 9.5p4 后、您会看到以下运行状况监视器警报：

 natestdal0505-ff::*> system health alert show Node: netapp_node_01 Resource: Link Aggregate 10 Severity: Major Indication Time: Thu May 16 15:44:16 2019 Suppress: false Acknowledge: false Probable Cause: The cable used to connect switch "netapp_switch_01/ Link Aggregate 10" to the ISL port might be faulty. Possible Effect: Cluster redundancy might be lost. Corrective Actions: 1) Check whether the cable is fully inserted into the interface port on both ends. 2) Reconnect the ISL port using another cable. After reconnecting it, verify whether the link of the ISL port is up by executing the commands as per switch configuration guide or by checking whether the Link status LED is on.