选项 6 会在四节点 MetroCluster 的 boot_recovery 过程中将 mcc 或 mccip 中的 ha-config 重置为 ha

最后更新
另存为PDF

Views:: 8

Visibility:: Public

Votes:: 0

Category:: metrocluster

Specialty:: metrocluster<a>MCC</a><a>FSE</a><a>MCCIP</a><a>ha-config</a><a>2008974421</a>

Last Updated:

适用场景

ONTAP 9
AFF A400
FAS8300
AFF A800
4 节点 MetroCluster FC
4 节点 MetroCluster IP

问题描述

在需要对运行 9.7.X 的四节点 MetroCluster 配置的 AFF A400 或 FAS8300 执行 boot_recovery 操作步骤（ ARL 标题交换，启动设备更换）的维护期间，在受影响节点上重新启动到 ONTAP 之前，必须将备份配置文件还原到新启动介质上。
请注意，尝试在特殊启动菜单中使用选项 6 还原 VARFS 备份配置文件失败。
在四节点 MetroCluster FC 配置中，您可能会看到类似的控制台消息如下所示。

Jun 13 08:09:04 [Node1:fci.adapter.error:notice]: Fibre Channel adapter driver encountered error "Either the platform does not support this type of FC/FCVI adapter, or the platform supports the adapter but the chassis and controller variables are not set correctly." on adapter 2a. Jun 13 08:09:04 [Node1:fci.adapter.error:notice]: Fibre Channel adapter driver encountered error "Either the platform does not support this type of FC/FCVI adapter, or the platform supports the adapter but the chassis and controller variables are not set correctly." on adapter 2b. Jun 13 08:09:29 [Node1:scsitarget.slifct.fwAutoBoot:notice]: FC target HBA 1c firmware version updated from 11.4.277.0 to 12.2.390.0. The controller will be rebooted automatically to enable the new HBA firmware. Rebooting after updating Emulex FC firmware.