跳转到主内容

在更改管理 IP 地址后、 ATTO 桥接请求是否重新启动 / 重新启动?

Views:
31
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

适用于

ATTO FibreBridge

解答

是的、在配置或修改 ATTO 管理 IP 地址后、必须运行命令 "" 并提示您重新启动网桥以使新配置SaveConfiguration生效。

注意:要在不使用 QuickNAV 实用程序的情况下设置 IP 地址,您需要与 FibreBridge 建立串行连接。

示例:
如果使用命令行界面,则必须运行以下命令:

set ipaddress mp1 ip-address
set ipsubnetmask mp1 subnet-mask
set ipgateway mp1 x.x.x.x
set ipdhcp mp1 disabled
set ethernetspeed mp1 1000
SaveConfiguration

系统会提示您重新启动网桥。

其他信息

 

 

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.